Observatory weather, rain protection and cloud advisories

WeatherWatcher & SafetyMonitor

Local RG-11 rain protection, NOAA satellite cloud information and optional Pushover warnings. Rain controls safety; clouds and notifications stay informational.

Rain protection stays local

The Arduino Uno reads the Hydreon RG-11 rain relay and isolated power monitor. Wet/rain, contact faults, power loss or lost serial communication prevent a SAFE result.

Existing automation uses UNSAFE to prohibit opening or close an open dome. A configurable dry-out delay defaults to five minutes. No Internet service is required for RG-11 protection.

NOAA replaces the IR sensor

The IR sky-temperature module has been removed. Windows reads the NOAA GOES-East ABI Level-2 Clear Sky Mask and calculates regional CloudCover around your observatory.

Defaults: 15 km radius, ten-minute polling and thirty-minute stale timeout. Cloudy conditions and failed or stale NOAA data do not change safety. Unavailable cloud data is reported unavailable, never zero.

Pushover cloud warnings

Optional phone/device advisories warn at 30% cloud cover and report clearing at 20%, with a configurable thirty-minute cooldown. Data-unavailable and recovered notices are optional.

Enter protected credentials under Cloud notifications... and send a labeled test. Alerts use normal priority and respect quiet hours. Delivery failures cannot delay rain handling or change SAFE/UNSAFE.

Keep your existing weather sources

Cumulus, Ambient Weather, weather limits and legacy Boltwood operation remain available. Arduino mode takes precedence over Boltwood; disabling it retains the existing file/API modes.

An independently selected Ambient API source retains its existing health checks. WeatherWatcher reports conditions and safety; your automation remains responsible for dome movement.

Set up the new workflow

  1. Close NINA and other ASCOM clients before installing matching drivers.
  2. Use the rain-only Uno sketch, remove the IR module and retain the RG-11 power/contact wiring.
  3. Enable NOAA cloud information; configure the COM port, dry-out delay and observatory coordinates.
  4. Optionally configure Pushover credentials, thresholds and cooldown.
  5. Keep ObservingConditions connected and use the matching SafetyMonitor. Bench-test rain, connection loss, recovery and automation closure.

Version 1.2.2 development

Current source pairs WeatherWatcher 1.2.2 with SafetyMonitor 1.3.1, preserving its AnyCPU compatibility fix. It includes the rain-only Arduino, NOAA cloud provider and Pushover notifications. Build current source to produce the combined installer; the releases page identifies packages already published.

231 offline checks passed, including rain safety during a stalled notification. Both Windows configurations and the installer build successfully; the Uno sketch compiled. NOAA decoding was independently verified against a real satellite product. No real Pushover messages or physical rain/dome tests are claimed. Installation and hardware qualification of this new build remain outstanding.

Current wiring and parts · NOAA method and limitations · Pushover setup · Bench checklist

Old IR wiring diagrams and Fritzing files are historical references. Follow the current RG-11 wiring table.

Independent rain and cloud options

Arduino rain protection and NOAA cloud information have independent checkboxes. Enable either, both, or neither according to your equipment. NOAA needs Internet access and observatory coordinates, but no Arduino. Arduino rain protection needs its USB COM port, but no NOAA connection. Pushover cloud advisories require NOAA enabled. Existing combined settings migrate with both options enabled.

Arduino mode grays out the Boltwood checkbox, file path and Browse button while preserving their saved values; Boltwood is ignored until Arduino is disabled. NOAA alone leaves Boltwood available for rain and sky temperature and replaces only its CloudCover reading. NOAA clouds remain informational and never veto safety.